NXC: how to SetRotationCount(OUT_A, longval) ?

[HaWe]

hi,
how can I set (patch) a RotationCount to a certain value?
by

Code: Select all

ResetRotationCount(OUT_A); 

I can set it to zero.

But if I want to set it e.g. to 300:

Code: Select all

SetRotationCount(OUT_A, 300);

how can I do this?

[mattallen37]

I don't think you can. The best way to mimic this behavior is to use offsets.

[afanofosc]

The firmware does not allow you to write to any of the tachometer fields of the Output module IOMap other than to reset the count to zero.

John Hansen

[HaWe]

a pity, but thank you for replying!